Rare Element Resources
Bear Lodge Project
Canadian NI 43-101 Technical Report
October 9
th
, 2014
10135-200-46 - Rev. 0
14-5
(A.Noble, 2014)
The oxidation state model was prepared using the oxidation state codes in the drill-
hole database, which designate drill-hole intervals as oxidized (Ox), oxidized with
calcite (OxCa), transition (Tran), or non-oxidized (Sulf). The initial interpretation was
done on cross-sections by drawing lines along the bottom of oxidized material, the
top of transition material, and the top of non-oxidized material. These lines were then
linked to form three-dimensional surfaces used to create the oxidation state model.
The top of the oxidized zone is defined as ten feet below the topographic surface,
Figure 14.2 - Typical Cross Sections through the Oxidation State Model
